in

connecting users of the CorelDRAW family of products
CorelDRAW.com » Graphics Suite products » Corel PHOTO-PAINT X4 » Mask Boundry is lost when I zoom in and out

Mask Boundry is lost when I zoom in and out

Last post 05-17-2008 8:22 by Alfred. 1 replies.
Page 1 of 1 (2 items)
Sort Posts: Previous Next

  • 05-16-2008 13:54

    Mask Boundry is lost when I zoom in and out

    Reply Contact

    Hi Folks,

    When I am creating a mask (with any of the mask tools), and I zoom in or out, I end up loosing the current selection points.  The 'ruberband' if  you will, is lost.  If I begin pickign again, the rubberband is all wacked out.. not sure what its doing.

     

  • 05-17-2008 8:22 In reply to

    • Alfred
    • Top 10 Contributor
      Male
    • Joined on 05-15-2007
    • Maine USA

    Re: Mask Boundry is lost when I zoom in and out

    Reply Contact

     I'm assuming you are talking about the free hand tool, yes that is annoying. I normally finish the selection by double clicking and then I zoom in and then I continue to make my selection, just make sure to select the additive mode before continuing the mask.

    Alfred
Page 1 of 1 (2 items)
© 2008 Corel Corporation. CorelDRAW and the CorelDRAW Balloon are trademarks or registered trademarks of Corel Corporation. The content herein is in the form of a personal web log ("Blog") or forum posting. As such, the views expressed in this site are those of the participants and do not necessarily reflect the views of Corel Corporation, or its affiliates and their respective officers, directors, employees and agents. Terms and Conditions.